NEON TRAY
Designer: Laura Fraedrich
SUPPLIES
Form
- MB-1064 Tray
Colors
Dunan colors
- CN501 Neon Yellow
- CN502 Neon Blue
- CN504 Neon Orange
- CN505 Neon Green
- CN507 Neon Red
- FD254 Black Licorice
- IN1026 Very Black
- PG Pure Brilliance Clear Brush-on
Decorating Accessories
- 5 AC-222 Large Bottles and Writer Tips
- CB-604 Soft Fan Brush
Miscellaneous Accessories
- Water
- Pencil
- Sponge
INSTRUCTIONS
- Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
- Using the CB-604 Soft Fan Brush, apply three coats of IN1026 Very Black to the back of the tray.
- Using a pencil, draw the design on the front of the tray using the photo as a guide.
- Using FD254 Black Licorice, go over all of your pencil lines. Let dry completely.
- Fill the five AC-222 Applicator bottles with the five colors of Neon Concepts – CN501 Neon Yellow, CN502 Neon Blue, CN504 Neon Orange, CN505 Neon Green, CN507 Neon Red. Make sure the glaze is the consistency of milk. Add a small amount of water to the glaze if you need to
- Apply two colors to each section by first applying one around the edge, then while still wet add a second color to the middle. Roughly swirl them together as you apply the second color. Use the following combinations: Red/Orange, Orange/Yellow, Yellow/Green, Green/Blue, Yellow/Red. Let dry.
- Using the CB-604 Soft Fan Brush, apply 2 coats of PG Pure Brilliance Brushing onto the front of the plate.
- Stilt and fire to cone 06.